Open Ground Receptacle

2018-02-17T14:01:25-05:00February 17th, 2018|

Ungrounded Or Open Ground Receptacle

Ungrounded or Open Ground Receptacles are a safety hazard and are in violation of the building and national wiring codes. They need be made safe immediately.

Newer Wiring

In homes where all the receptacle were installed with a ground, any failure of the ground must be corrected by replacing the failing receptacle, or replacing and/or reconnecting the ground wire. In many cases the open ground on one receptacle is the result of a disconnected wire at another receptacle. A wire disconnected from one receptacle will disconnect the ground service from all the receptacles down line.

Older Wiring

In older homes the original wiring did not have ground wire connected to the receptacles. These ungrounded receptacles are easily distinguished by their two hole / slot configuration verses the newer grounded type of receptacle that has three holes / slots. Ungrounded receptacles that have two holes / slots used in a home that was originally wired in this manner and has not been rewired are considered acceptable.GFCI Receptacle

Where the Problem Begins

The problems for the owners of older homes start when grounded type receptacles are substituted for the ungrounded type without the necessary rewiring that adds a ground wire to the new three prong grounded type receptacle. Grounded type (three hole / slot) receptacles may not be substituted for ungrounded receptacles unless a ground wire is connected.

An exception to this rule is allowed by the National Electric Code, when the receptacle is protected by a ground fault interrupter (GFI or GFCI).

The Fixes

There are two fixes available for those home owners who do not want to rewire the entire house.

The first fix uses Ground Fault Interrupters. There are two types of GFI available, one takes the place of the regular circuit breaker in the load center. The second type that is available takes the place of the standard outlet and replaces it with a special GFI protected receptacle. These are commonly used in the kitchens and bathrooms of newer homes. Most people know them for their black and red reset buttons.

The second fix – In many older homes the receptacle mounting box was grounded but the receptacle was not, if this the case it is possible to use a jumper between the mounting box and the grounding screw on the new grounded type receptacle. This type of ground may not be adequate for surge protectors.

Surge Protectors

A surge protector plugged into an ungrounded outlet will not operate as the manufacturer intended. When a large surge or spike hits, the surge protector uses the ground wire to take the “hit” away from the protected equipment and send it safely to ground. If the surge or spike is not sent to ground by the surge protector it will destroy the delicate electronics you were trying to protect. The warranty offered by the surge protectors manufacturer offer, is only valid if the surge protector is used in a properly grounded outlet.

Video courtesy of The Sparky Channel